Tutorials

tutorial: that lime green necklace

Share

i keep getting comments and emails over this necklace and weather or not i was going to show you how i did it. okay well it’s not that complicated i think you can figure out that i strung wooden beads. so this tutorial will be for how i got an even coat over my beads with spray paint.
*i used a styrofoam half sphere (in the flower section in the craft store, or walmart.)
*i then got tooth picks.
*because the holes in the beads were wider than the tooth picks i put a little piece of tin foil at the tips of the toothpicks.
*i also used my left over spraypaint “ivy leaf” by krylon. (IN.LOVE.WITH.THAT.COLOR)

*i placed the styrofoam inside a box ( it’s too cold to do it out in the back yard, and now i either have to do it indoors or in the garage).
*i then LIGHTLY sprayed the beads. let them sit for a little (like 5 minutes) and then repeated.
*let them dry completely
then i flipped them over and did the same step as i did on the other side.
let them dry, flip them over AGAIN, repeat steps till you get it completely covered with paint and you are happy with it.
i did 3 “flips” because i wanted the paint to be really solid. no wood showing through.

i love the combo of brown and lime green so i chose brown ribbon for the necklace.
i made sure i had enough ribbon at my “ends” that it would be easy to tie my necklace around my neck.
* then i made a knot.
i then stranded my beads. i wanted a few off centered big beads so i placed them accordingly.
tie off your other end and make sure you put Fray Check on your ends of your ribbon so the ribbon stays intact.
and there you have it.
😉
comments closed

Looking for Vanessa Christenson's

Life Coaching Website?